Table of Contents
Advertisement
Table 33. Processor Settings details (continued)
Option
CPU Crash Log Support
Processor n
Table 34. Processor n details
Option
Family-Model-Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Microcode
SATA Settings
To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
SATA Settings.
Table 35. SATA Settings details
Option
Embedded SATA
Security Freeze Lock
Write Cache
NVMe Settings
This option sets the NVMe drive mode. If the system contains NVMe drives that you want to configure in a RAID array, you
must set both this field and the Embedded SATA field on the SATA settings menu to RAID Mode. You may also need to change
the Boot Mode setting to UEFI.
Description
The feature supports operating system recovery for cases of
multiple recoverable faults that are detected close, which would
otherwise result in a fatal machine check event. The feature is
available only on Advanced RAS processors. This option is set to
Enabled by default.
This field controls Intel CPU Crash Log feature for collection
of previous crash data from shared SRAM of Out-of -Band
Management Service Module at post reset. This option is set
to Disabled by default.
The following settings are displayed for each processor:
Description
Specifies the family, model, and stepping of the processor as
defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
Specifies the processor microcode version.
Description
Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes.
This option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you
should set the field to Non-RAID mode.
2. No ESXi and Ubuntu OS support under RAID mode.
Sends Security Freeze Lock command to the embedded SATA drives during POST.
This option is applicable only for AHCI Mode. This option is set to Enabled by default.
Enables or disables the command for the embedded SATA drives during POST. This
option is applicable only for AHCI Mode. This option is set to Disabled by default.
NOTE:
Depending on the number of processors, there might
be up to n processors listed.
Pre-operating system management applications
39
Advertisement
Table of Contents
