SMART MX V2 Pro Series Installation And Maintenance Manual page 28

Chapter 2
Installing the display
To turn on and set up the display for the first time
IMPORTANT
Install the OPS PC module before you turn the display on.
NOTES
Touch is not available right after waking up the display or turning it on. Wait a few seconds and then
l
the display will respond to touch.
If a USB drive is connected to the display's service port, do not remove the USB drive. The USB
l
drive contains an important firmware update.
1. Flick the switch beside the AC power inlet to the ON (I) position.
SBID-MX255-V2
2. Press the Power button
3. Select your preferred language, and then tap Next.
4. Select your country, and then tap Next.
5. Select your time zone, and then tap Next.
6. Set the date, and then tap Next.
7. Set the time, and then tap Next.
8. Name the display, and then tap Next.
9. If the display isn't using a wired network connection, select a wireless network, and then tap Next.
IMPORTANT
The display needs an internet connection for downloading and installing important updates. Ask the
network administrator to confirm that the network has been correctly configured for the iQ
experience. For more information about network configuration, see
with the iQ experience to a
smarttech.com/kb/171555
SBID-MX265-V2
on the front control panel or remote control
network.
SBID-MX275-V2
SBID-MX286-V2
Connecting a SMART display
28