Lubrication; Greasing The Tine Shaft Bearings; Lubricating And Checking The Drive Chains And Sprockets - Toro 23515 Operator's Manual

Figure 27
2. Support the front of the machine with a jack
stand.

Lubrication

Greasing the Tine Shaft
Bearings
Service Interval: Every 25 hours
Every 25 hours
Grease Specification: NGLI grade No. 2
g371342
multi-purpose
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 21)
2. Remove the rear access panel; refer to
Removing the Tine Access Cover (page
3. Lubricate the grease fittings with a grease gun
and the specified grease; refer to the Lubrication
Chart for the fitting locations.
Lubrication Chart
Fitting Location
1. Tine Shaft
Bearings
2. Tine Assembly
Idlers
4. Install the rear access panel; refer to
the Tine Access Cover (page
Lubricating and Checking
the Drive Chains and
Sprockets
Service Interval: Before each use or daily—Check
Before each use or daily—Check the condition
of the front drive chains.
Before each use or daily—Check the condition
of the drive chain sprockets.
Before each use or daily—Lubricate the
tine-drive chains.
22
Initial Number
of Pumps
1
1-2
21).
the condition and tension of the
tine-drive chains.
21).
Number of
Places
2
2
Installing