Checking The Pto Angle; Fitting The Pto Shaft - Toro ProCore SR54 Operator's Manual

Figure 10
1. Damage will occur here.
7

Checking the PTO Angle

No Parts Required
Procedure
Important:
Before checking the PTO angle,
remove the tines.
1. With the aerator positioned on the ground and
lowered to the deepest location, use an angle
indictor to measure the angle between the PTO
and the aerator.
2. Lift the aerator and fully retract the hydraulic top
link cylinder.
3. Using an angle indictor, check the angle
between the PTO and the aerator.
4. If your measurement is greater than 35°, perform
1 of the following to adjust the traction unit so
that you cannot raise the aerator past 35°.
•
Use the lift stop of the traction unit (if
equipped).
•
Move the lower links to a higher mounting
hole (if equipped).
8

Fitting the PTO Shaft

Parts needed for this procedure:
1 PTO shaft
Procedure
g010803
1. Park the traction unit and aerator on a level
surface.
2. Raise the aerator completely and fully retract the
hydraulic top link cylinder or upper link
11).
3. Measure the distance from the locking groove
at the end of the traction unit PTO shaft to the
locking groove at the aerator gearbox shaft
(Figure 12).
Record this measurement here:
)
INCHES
1. Measure here
4. Lower the aerator to the ground and fully extend
the hydraulic top link cylinder or upper link
(Figure 13).
13
Figure 11
E : 67 (26-1/2
XAMPLE CM
Figure 12
2. Locking groove
(Figure
g010798
g237884