Removing A Dirt Hopper; Emptying The Dirt Hopper; Inserting The Dirt Hoppers; Changing The Seals - HAKO Sweepmaster P800 Instruction Manual

Safety Information

5.9.1 Removing a dirt hopper

1. Switch the machine off and move the
lever (Fig. 24/5) for locking the dirt
hoppers to the right (looking in drive
direction) and, at the same time,
pivot the handlebar (Fig. 24/4)
forwards. The frame (Fig. 25/2) of
the dirt hopper is lowered.
The engine must be at a
standstill before one or both
dirt hoppers (Fig. 24/3) are
removed. Risk of injury through
swirling waste and dust!
2. Hold the dirt hopper (Fig. 24/3) by
the handle (Fig. 24/2) and pull it to
the rear and out of the machine
56
1 1
2
Fig. 25

5.9.2 Emptying the dirt hopper

Check the fill level of the dirt hoppers
(Fig. 24/3) regularly and empty it
regularly and as necessary.
Observe the applicable
national laws and local
regulations when disposing of
waste.

5.9.3 Inserting the dirt hoppers

1. Insert the dirt hoppers (Fig. 24/3)
back in the machine from the rear
until they perceptibly engage in the
frame (Fig. 25/2).
2. Pivot the handlebar (Fig. 24/4)
towards the rear until the lever
(Fig. 24/5) for locking the dirt
hoppers audibly engages.

5.9.4 Changing the seals

Check the dirt hopper seals (Fig. 24/1)
(Fig. 25/1) for wear on a weekly basis
and change the seals as necessary.
1. Remove the dirt hoppers,
refer to paragraph 5.9.1.
2. Pull the seals (Fig. 25/1) from the
edges.
3. Press new seals (Fig. 25/1) on the
edges.
4. Insert the dirt hoppers,
refer to paragraph 5.9.3.