Table of Contents
Advertisement
Safety Information
1.4
Maintenance information
• The maintenance work and
maintenance intervals prescribed in
the operating manual must be
adhered to.
• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other
maintenance work must be
completed at your nearest Hako
service center.
• The machine must be inspected by a
recognized technical expert in
respect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable
intervals (we recommend at least
once a year) and following
modification or repairs.
• Spare parts must comply with the
minimum technical requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• The machine must be switched off
prior to cleaning or servicing it or to
replacing parts.
10
• Suitable tools must be used for
cleaning and maintenance work.
• When working with the hood raised,
it must be opened up fully to prevent
it from accidentally dropping or
slamming shut.
• When working on the electrical
system, always disconnect the
battery cable (only Sweepmaster
B800).
• Batteries may only be handled and
changed by properly skilled
maintenance personnel (only
Sweepmaster B800).
• Pay attention that the insulation of
the charger cable is not damaged
and cannot be damaged during the
charging process. The cable must
not chafe against anything. In the
case of defective insulation, do not
use the on-board charger (only
Sweepmaster B800).
• Check the exhaust system at regular
intervals (only Sweepmaster P800).
• It is not permitted to clean the
machine with a pressure washer or
steam blaster.
• It is not permitted to use aggressive
and corrosive cleaning agents.
• Allow the machine to dry properly
after being cleaned, e.g. over the
weekend.
• Do not carry out any welding, drilling,
sawing or grinding work on the frame
sections. Damaged parts may only
be changed at an authorized Hako
service center.
Advertisement
Table of Contents
