Table of Contents
Advertisement
Safety Information
5.5.1 Charging batteries
Before starting the machine up
for the first time, the batteries
to be used must be fully
charged, properly, by
implementing the initial battery
charge routine. Hako assumes
no liability for damage to the
battery caused by a fault when
the battery is charged for the
first time.
During operation, the battery discharge
indicator in the operating panel
(Fig. 15/3) indicates the discharge
status of the batteries, refer to
paragraph 3.2.2, Section "Battery
discharge status (Fig. 10/3)". The
batteries must be charged immediately
the red LED lights up. The batteries
(Fig. 15/6) are recharged using the
integrated on-board charger (Fig. 15/2):
1. Set the key switch to Position 0.
The batteries cannot be
charged in Position 1.
2. Remove the charger cable
(Fig. 15/1) from the recess on the
right-hand side of the machine.
3. Plug the charger cable
(Fig. 15/1) in a 230 V power outlet.
While the battery is charging, the
charge control indicator lights up in the
operating panel (Fig. 15/3), refer to
paragraph 3.2.2, Section "Charge
control indicator (Fig. 10/2)".
When the charging process
has been completed,
disconnect the plug from the
power outlet and return safely
to the recess.
5.5.2 Total discharge signal
transducer (TSG)
The machine is equipped with a total
discharge signal transducer to protect
the batteries against total discharge.
The total discharge signal transducer is
integrated in the electronics.
5.5.3 Servicing the drive batteries
Never leave discharged batteries lying
around; recharge them immediately!
Notes on servicing drive
batteries is also provided in
supplementary sheet
88-60-2556 "Information on
Drive Batteries".
5.5.4 Removing batteries
Before the Sweepmaster B800
is tipped for any reason, the
batteries must be removed!
1. Unlock the hood (Fig. 15/5) using a
square wrench and open the hood
(Fig. 15/5).
Ensure the engine has
stopped before opening the
hood. Risk of injury through
belt drive and rotating fan!
2. Disconnect the negative cable from
the batteries (Fig. 15/6).
3. Disconnect the positive cable from
the batteries (Fig. 15/6).
4. Remove the connection cable from
between the two batteries(Fig. 15/6).
5. Release the retaining strap.
43
Advertisement
Table of Contents
