Choosing The Contact Points - Dog trace d-control 500 mini User Manual

INSERTION (REPLACEMENT) OF THE BATTERY IN THE TRANSMITTER
Remove the transmitter battery cover using a cross-head screwdriver.

If replacing the battery, remove the old battery and dispose of it properly.

Place the alkaline AA 1,5V batteries in the holder and press into place. Observe polarity when

installing the batteries. Reversing the batteries may damage the transmitter.
Put the battery cover back into place and secure with screw.

THE BATTERY LEVEL IS SHOWN AT THE BATTERY LIFE STATUS BAR ON THE LCD DISPLAY.
Battery fully charged: full battery icon is shown on the LCD display.

Low battery: battery empty icon is shown on the LCD display.

Prepare two spare alkaline AA 1,5V batteries and follow the instructions described in the section
„Insertion (replacement of the battery in the transmitter".

Choosing the contact points

The stimulation is delivered through the receiver contact points. Two different series of contact points
are supplied. The length of the contact points must be sufficient to have proper contact with the dog's
skin, enabling the device to operate correctly. If you have a short-haired dog use the short 12 mm
contact points, if you have a long-haired dog replace them with the longer 17 mm contact points
supplied with the kit. Carefully tighten them manually (do not use a key). It is possible to purchase the
21 mm long contact points.
7