Dog trace d-control 500 mini User Manual page 11

Button -Booster
Pressing the „Booster button" enables you to use different levels of pre-set stimulation intensity at the
transmitter. The stimulation is transmitted by the two contact points located on the receiver as long as
the button is pushed. If the button is not released after 4 seconds, the stimulation will automatically
turn off as a safety feature. The receiver will be ready to be reactivated once the button has been
released. While pressing, an indicator of the radio transmission will appear on the LCD display of the
transmitter; the indicator light on the receiver goes from flashing green to permanent red.
Programming the „Booster button":
press the selection button

on the LCD display.
press the

press the selection button

select dog using the button on the transmitter and proceed in the same way (applicable when

programming „Booster function" for the second receiver).
Up/Down control buttons
The control buttons are used for quick adjustment of the stimulation level of the receiver. The selected
intensity level is shown on the LCD display. There are 30 stimulation levels with 1 being the lowest and
30 being the highest. When any button is pressed the LCD display lights up for three seconds.
Dog selection buttons
The control buttons 1 and 2 are used for quick dog selection when using the device for training two
dogs simultaneously. It is possible to set different level of stimulation for each dog
for approximately 5 seconds until the level of stimulation flashes
button to increase or decrease the level of stimulation.
to confirm the level selected.
11