Cleaning; Safety Information For Cleaning; Cleaning Procedures - Berbel Skyline Curve Operating And Installation Instructions

Cleaning

5. Cleaning
5.1

Safety information for cleaning

D WARNING!
Hazard through a disregard of the cleaning instructions!
This chapter contains important information for the safe
cleaning of the device.
☞ Read through this chapter carefully before cleaning the
device.
☞ Follow the safety instructions.
y Cleaning only by authorised users.
D "1.2 Authorised target groups" (page 4).
y No cleaning permitted by children under 8 years old and
persons who would not be able to properly assess the
hazards associated with handling the device.
y After use, the hob and other parts that could be touched
may still be hot. There is a risk of burning.
y Grease residues should be removed. Grease residues pose
a fire hazard.
The device should be cleaned regularly:
y Control panel, surface, upper section and lower section
each time after cooking.
y The Capillar Trap after 8 - 10 weeks at the latest when
used daily.
20
5.2

Cleaning procedures

The device draws in dirt particles (e.g. grease and oil particles)
with the air from the room. The dirt particles are separated off
and collected in the upper section, the lower section and in
the Capillar Trap.
Before every cleaning:
☞ Turn off the device.
☞ Make sure that the hob and other parts that could be
touched have cooled down.
D ATTENTION!
Danger of damage through improper cleaning!
Sharp-edged objects, abrasive or unsuitable cleaning agents
can damage the device.
The following cleaning agents are unsuitable and must not
be used:
y Acetone
y Trichloroethylene
y Solutions on a cellulose basis (e.g. cellulose thinner)
y Artificial resin thinner
y Abrasive media
y Polishes containing silicone
y Polishes containing oil
y Wax
y Water vapour
y On painted surfaces: Microfibre cloth
☞ Keep objects that could scratch the device away from it
(e.g. rings).
☞ Use mild household cleaner (e.g. alkali-free, pH-neutral
multipurpose cleaner).
☞ Use a soft, damp cloth.
☞ Clean without exercising excessive pressure.
 The instructions and information on the cleaning agent
should be observed.
Remote control
☞ Clean the remote control with a lint-free, slightly damp
cloth (e.g. a microfibre cloth).
☞ Dry the remote control with a lint-free, soft cloth.
Surfaces
☞ Clean the surfaces with a soft, damp cloth and a mild
household cleaner.
☞ Dry the surfaces with a soft cloth.
6006241_0 – 30.05.2022