Sartorius PMA Evolution Operating Instructions Manual page 24

Operation
118.0
STO 01
02
110.0
STO 02
03
203.0
C
200.0
COR 01
C1
C1
COR 02
C2
C2
24 EVO1S | SPO1S Operating Instructions
The scale calculates the amount to be added for each of the components that
y
were already poured . The display shows the amounts required to correct the
formula up to the point at which the overpour occurred .
After the correction has been completed, you can continue filling the remaining
t
components .
You can correct overpours as often as needed .
Keep in mind that the total quantity of paint (liter) at the conclusion of filling
increases each time you correct a component . Press the § key to display the
correction factor of the fill quantity . "C" = correction factor
Recalculation Example (Gross Weight)
For legal metrology models, the displayed value is marked with an l symbol to
indicate computed values .
Place the empty container on the weighing pan .
t
The scale shows the weight of the empty paint can .
y
Briefly press the 0 key to tare .
t
0.0
Slowly add the first component (50 g) of the formula until the display shows
t
50.0
"50 g ."
Briefly press the ! key to save the value .
t
"STO 01" appears on the display, the first value is saved .
y
"02" appears in the top left of the display (second color component) .
y
Add the second color component "110 g" until the display shows "110 g ."
t
Briefly press the ! key to save the value .
t
"STO 02" appears on the display, the second value is saved .
y
"03" appears in the top left of the display (third color component) .
y
Add the third color component (200 g) until the display shows "200 g ."
t
Oops! You poured in too much (203 g). The correct value for the formula is
200.0 g.
Press the P key .
t
The recalculation is started . "C" flashes in the top left of the display .
y
Press the P key until the correct weight value "200 g" is displayed .
t
Briefly press the ! key to confirm the corrected value .
t
"C0R 01" flashes briefly on the display (correction of the first color component) .
y
"C1" appears in the top left and the weight value to be corrected "- 1 .7 g ."
y
1.7
Add 1 .7 g of the first color component until the display shows "0 .0 g" or the bar
t
0.0
graph stops below the green arrow .
Confirm the correction for the first color component by pressing the ! key .
t
"C0R 02" flashes briefly on the display (correction of the second color
y
component) .
"C2" appears in the top left and the weight value to be corrected "- 2 .0 g ."
y
2.0
Add 2 .0 g of the second color component until the display shows "0 .0 g" or the
t
0.0
bar graph stops below the green arrow .