Switching Between Full Screen Video And The Home Screen; Showing, Moving, And Turning Off The Pip - Polycom VSX3000 Getting Started Manual

G S G
ETTING TARTED UIDE FOR THE

Switching Between Full Screen Video and the Home Screen

Showing, Moving, and Turning Off the PIP

12
VSX S
ERIES
Before the call connects, you see the near video in a small window on the
Place a Call (home) screen. When the call connects, the system automatically
shows the video in the whole screen. You can switch back to the Place a Call
screen during a call, for example, if you need to adjust a user setting, and
your system is configured to allow you to do so.
To learn about adjusting user settings, see Customizing Your Workspace on page 40.
To see the video in the full screen:
Press Near on the remote control.
To see the Place a Call screen:
Press Home on the remote control.
Your system may be configured to display a Picture-in-Picture (PIP) window.
During a call on a single-monitor system, the PIP displays what your main
camera is sending to the far site. (This lets you adjust the camera if you need
to.) If the far site shows any type of content, the content appears in the main
part of the screen, and the PIP changes to show the people at the far site.
During a call on a dual-monitor system, what you see on each monitor and in
the PIP depends on how the VSX system has been configured.
To show, move, or turn off the PIP during a call:
Press PIP on the remote control to display the PIP on screen.
While the PIP has a yellow border, press
different corners of the screen.
After a brief pause, the PIP border turns blue. Then, press
turn the PIP off.
PIP repeatedly to move it to
. . /
WWW POLYCOM COM VIDEODOCUMENTATION
PIP to