Cables And Connectors - Nortel Media Gateway 1000E PRI Installation And Comissioning Manual

44 System components

Cables and connectors

The PRI Gateway on the chassis includes the existing six RJ-45 Ethernet
connectors (four on the faceplate and two in the back panel) and one
RS-232 connector.
The PRI Gateway includes the following physical connectors for the E1/T1
card:
•
•
•
•
These cables are provided:
•
•
•
All the cables listed here including the MGC cables as well as the connectors
listed here are not provided by Nortel and are the responsibility of the
distributor to provide:
•
•
•
•
•
Media Gateway 1000E PRI Gateway Installation and Commissioning
Copyright © 2007, Nortel Networks
.
Ethernet connector. The E1/T1 card is connected to the ELAN subnet
through the CE ports on the MGC.
RS-232 connector. This connector is on the back panel of the E1/T1
card for installation and monitoring. This connection is used for
initial configuration of basic LAN parameters in the command line
interface (CLI). (After installation, all configuration, administration and
maintenance is carried out through the Web-based interface.)
Eight RJ-45 connectors on the back panel for the E1/T1 interfaces. The
PRI Gateway does not provide BNC (co-axial) connectors.
Two RJ-45 connectors on the back panel for dual homing
power cord
Ethernet cable (NTDU0606E6)
up to eight shielded RJ-45 E1/T1 cables
Power supply cable
RJ-45 Ethernet shielded cable
RJ-45 E1/T1 shielded cables
RS-232 serial port (D-type 9) cable
BNC connectors
Note: If you require a coaxial cable to RJ-45 cable converter or adaptor,
the RoHS compatible part is A0741330—Balum Impedance Converter
70 OHM Coax Male 120 OHM RJ-45.
Nortel Communication Server 1000
NN43041-311 01.01 Standard
Release 5.0 30 May 2007