Table of Contents
Advertisement
13 WHEELS, TIRES
13.3
76
F03045-10
F03005-10
Removing the rear wheel
F02209-10
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
spacers.
Long-life grease (
p. 110)
–
Insert the spacers.
Info
Insert the wide spacer on the left in the direction of travel.
–
Clean and grease the wheel spindle.
Long-life grease (
p. 110)
–
Position the front wheel.
The brake linings are correctly positioned.
–
Insert the wheel spindle.
–
2
Mount and tighten screw
Guideline
Screw, front
M10
wheel spindle
–
Operate the hand brake lever several times until the brake linings
are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
3
Tighten screws
.
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Remove nut
.
–
2
Take off chain adjuster
.
1
A
and contact surfaces
.
40 Nm (29.5 lbf ft)
Loctite
p. 37)
M6
10 Nm (7.4 lbf ft)
p. 37)
of the
®
243™
Advertisement
Table of Contents
