Ftp/Nas/Memory Card Uploading; Send Email - HIKVISION iDS-2CD70C5G0/H-AP User Manual

2. Set the alarming schedule. For the information about the settings, see Set Arming Schedule .
3. Optional: Click Copy to... to copy the parameters to other alarm output channels.
4. Click Save.

7.2.2 FTP/NAS/Memory Card Uploading

If you have enabled and configured the FTP/NAS/memory card uploading, the device sends the
alarm information to the FTP server, network attached storage and memory card when an alarm is
triggered.
Refer to Set FTP to set the FTP server.
Refer to Set NAS for NAS configuration.
Refer to Set New or Unencrypted Memory Card for memory card storage configuration.

7.2.3 Send Email

Check Send Email, and the device sends an email to the designated addresses with alarm
information when an alarm event is detected.
For email settings, refer to Set Email .
Set Email
When the email is configured and Send Email is enabled as a linkage method, the device sends an
email notification to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email function. Go to Configuration → Network → Network
Settings → TCP/IP for DNS settings.
Steps
1. Go to email settings page: Configuration → Event → Alarm Setting → Email .
2. Set email parameters.
1) Input the sender's email information, including the Sender's Address, SMTP Server, and
SMTP Port.
2) Optional: If your email server requires authentication, check Authentication and input your
user name and password to log in to the server.
3) Set the E-mail Encryption.
When you select TLS, and disable STARTTLS, emails are sent after encrypted by TLS. The
●
SMTP port should be set as 465.
When you select TLS and Enable STARTTLS, emails are sent after encrypted by STARTTLS,
●
and the SMTP port should be set as 25.
Network Camera User Manual
46