Table of Contents
Advertisement
Note
This function is only available for certain device models under certain settings. Please refer to
the actual settings.
4. Click
. Click and drag the mouse on the live image, and then right click the mouse to finish
drawing one area.
5. Optional: Click
6. Optional: You can set the parameters of multiple areas by repeating the above steps.
6.2 Set Video Tampering Alarm
When the configured area is covered and cannot be monitored normally, the alarm is triggered and
the device takes certain alarm response actions.
Steps
1. Go to Configuration → Event → Event and Detection → Video Tampering .
2. Check Enable.
3. Set the Sensitivity. The higher the value is, the easier to detect the area covering.
4. Click
and drag the mouse in the live view to draw the area.
Network Camera User Manual
to clear all the areas.
38
Advertisement
Table of Contents
