Table of Contents
Advertisement
Remote Interface
Remote Connectors
GPIB Interface
Parallel Interface
D–4
The platform has a parallel port, a serial port (RS-232 or Ground Closure
interface), and an optional GPIB port. You can use any of these ports for
downloading signal sets from the SDP2000 Signal Development Program or for
remote control of the platform and modules. The following paragraphs provide
more information about these remote interfaces, and Figure D–1 shows the
rear-panel connections.
RS-232/Ground
GPIB
Closure interface
interface
CPU
Optional
module
GPIB
module
Parallel
interface
Figure D–1: Rear panel remote connectors
The optional GP1 Interface module provides a GPIB interface. For information
on this interface, refer to the GP1 Interface Module User Manual.
This Centronics-compatible parallel interface uses the 25 pin D-type connector
on the rear panel of the CPU module. For proper operation of the parallel
interface, ensure that all 25 connector pins are connected straight through your
cable. If the Parallel port does not work with your PC, try using a newer parallel
port on your PC, or use the Serial port.
TG 2000 Signal Generation Platform User Manual
Advertisement
Table of Contents
