Table of Contents
Advertisement
Getting Started
Software Installation
1–8
Figure 1–4: Placing the TG 2000 Signal Generation Platform in the rack
To remove the TG 2000 Signal Generation Platform mainframe from the rack,
follow these steps:
1. Slide the mainframe out until it stops at the catches.
2. Support the mainframe while you press in on the stop latch buttons on each
side. This action will free the TG 2000 Signal Generation Platform to slide
completely out of the rack.
3. Provide support while you slide the mainframe out of the rack.
There are three types of software you can install:
The SDP2000 Signal Development Program (use the disks and instructions
included in the SDP2000 User manual, standard accessory).
Signal sets for each module type (use disks and instructions included in the
module user manual). If you purchased your modules installed in a main-
frame, signal sets are already installed for you.
Module or mainframe firmware. In certain instances, a firmware upgrade kit
may be issued, including disks and instructions. You will not usually install
instrument firmware; it is already installed in your mainframe and modules.
Side-out track
Stop latch
TG 2000 Signal Generation Platform User Manual
Advertisement
Table of Contents
