IDEAL MSC-13K-B Manual page 19

4.7 OPERATING THE PALLET LIFTING MECHANISM
The pallet jack mechanism is operated by means of the handle bar and the lever
inside the bar. (Fig. 9)
The lever has two positions:
1 When the lever is pulled up in the upper position (1), the pallet jack mechanism
can be raised by moving the handle bar up and down.
2 If hand released, the lever will be back to its neutral position. The pallet jack
mechanism is lowered and the lift will sit on ground.
Steps to move the column lift with pallet jack:
1 Pull up the lever to position (1) and make some pumping movement with the
handle bar to raise up the column lift. Then the column lift can then be relocated.
2 Release the lever to position (2) to lower down the column lift to the floor
after it is right located.
Note: Set the pallet lifting mechanism in the lowest position, and the lever to
the neutral position (2), whenever the column lift is to hoist a vehicle.
Fig. 9 Pallet Lifting
19
Nov. 2021
MSC-13K