IDEAL MSC-13K-B Manual page 15

4.5 TRAVEL DISTANCE AND HEIGHT UNIT CHANGING
4.5.1 TRAVEL DISTANCE CHANGE
If the lifting height is less than 67" (170cm) due to low shop ceiling, the travel distance
shall be set in following steps before starting the lifting operation.
1. After power on, waiting the LCD screen to be the LCD screen 4th, then press ESC
button [18] to change to system menu. ( LCD screen 5
2. When 'USER MENU' is high-lighted, press ENTER button [17] to enter the sub
menu of USER MENU. ( LCD screen 6
USER MENU
OPERATOR MENU
DIAGNOSTICS MENU
RELEASE PASSWORD
LCD screen 5
3. Press DIRECTION DOWN button [8] to move to 'Set of Travel' as in LCD screen
th
6 .
4. Press ENTER button [17] again to enter the travel distance modification screen.
(LCD screen 7
5. To change the travel distance, using 'DIRECTION' buttons [7], [8], [9] and [10] to
move cursor to the percentage on the screen then change the number.
Note: The percentage range is 60%--100%. Min. step is 2" (5cm).
6. Press ENTER to confirm the modification and press ESC to exit this function to
upper menu. (LCD screen 8
4.5.2 HEIGHT UNIT CHANGE
1. From LCD screen 6
(LCD screen 8
2. Press ENTER button [17] to enter the unit modification screen. (LCD screen 9
3. To change the unit, using 'DIRECTION' UP and DOWN buttons [7], [8] to
change the number. '1' refers to inch. '0' refers to cm.
th
1. Use arrow key to edit:
Max.
170 X
2. Press ENTER then ESC
th
)
th
)
th
, Use 'DIRECTION' buttons to choose 'Set of Unit'.
th
)
th
)
Parameters List
Set of Travel
Set of Unit
Special Terms
LCD screen 6
% Travel
100 >= 170 cm
th
LCD screen 7
15
Nov. 2021
MSC-13K
th
)
th
th
)