IDEAL MSC-13K-B Manual page 16

4. Press ENTER [17] to confirm the modification and press ESC [18] to exit
this function to upper menu. (LCD screen 8
Parameters List
Set of Travel
Set of Unit
Special Terms
LCD screen 8
4.5.3 UNIFORM HEIGHT REFERENCE
After travel distance and unit modification, the screen is back to LCD screen 4th. If
press START button (15) at this step, the screen change to 10th.
Mode: II..II
L2 0 L4 0
L1 0 L3 0
⊙Stop!
(Here the L1, L2, L3, L4, L5, L6 are to indicate the position of height reading of each
column. They are not shown in screen in operation)
In this LCD screen 10th, the bias 'Z___' means the system height reference is in
uniform height reference. The height reading is zero while the lifting fork at the bottom
as it is set in factory. While in VEHICLE mode or AXLE mode, the lifts will be in same
height while lifting or lowering
The right row L5 and L6 reading (0, 0) in the screen is no meaning. The software can
work for 6 columns in all for cable model.
4.5.4 CUSTOMIZED HEIGHT REFERENCE
If for any reason, the height of different column shall be kept differently, (difference is
greater than 2"/50 mm), the Customized height reference shall be chosen as following.
1. Press WHEEL / SINGLE button [11] change the screen into LCD screen 11th.
2. Press UP button [3] on one column to raise single column to desired height. Repeat
for other three columns.
In this step, the height of each column shall keep the vehicle in horizontal.
Never try to rise up too much or it will cause vehicle to move, to drop. Each
pressing can only keep moving for about 5 seconds.
th
bias: Z___
L6 0
L5 0
or
LCD screen 10
WARNING!!
th
)
Unit: Current
1. Use arrow key to edit:
0---cm;
2. Press ENTER then ESC
LCD screen 9
Mode: II..II
L2 0 L4 0
L1 0 L3 0
Reset
th
16
Nov. 2021
MSC-13K
0 cm
1---inch
th
bias: Z___
L6 0
L5 0