IDEAL MSC-13K-B Manual page 14

Note: If necessary, the lifting height / travel distance shall be changed before
press SHIFT and START buttons. (See 3.4 section)
5. Take care that the emergency stop button of each lifting column must been
released.
6. Operation description
All system functions are available by press the MODE buttons [11], [12], [13] when
the lift columns are not in operation (non of button [3], [4], [5] is pressed).
When the Mode is ALL / Vehicle ( II..II )
-Press any button 3 ⇑ , all columns are raised.
-Press any button 4 ⇓ , all columns are lowered.
-Press any button 5 ⇓ , all columns are lowered and locked.
When the Mode is WHEEL / Single ( I )
-Press one button 3 ⇑ , that column is raised.
-Press one button 4 ⇓ , that column is lowered.
-Press one button 5 ⇓ , that column is lowered and locked.
When the Mode is Axle / Pair ( II )
-Press one button 3 ⇑ , that two columns in same axle are raised.
-Press one button 4 ⇓ , that two columns in same axle are lowered.
-Press one button 5 ⇓ , that two columns in same axle are lowered and locked.
Note: In WHEEL or AXLE mode, the lifting or lowering will be stopped when the
height difference between columns or axles is greater than 2" (50 mm)
14
Nov. 2021
MSC-13K