Table of Contents
Advertisement
3.
Determine which board will support VGA display:
• The Md4/PCV board (See below.)
• Another VGA board (See page 8.)
To install multiple Md4/PCV boards, see page 14 for
instructions.
Using the Md4/PCV board to support VGA display
When you use the Md4/PCV board to support VGA display, you
set the board as the VGA console. This enables the Md4/PCV
board to support VGA display and run the DOME Windows
driver simultaneously.
To set the board as the VGA console
1.
Remove the existing VGA board from your computer.
2.
Enable VGA mode on the Md4/PCV board. (See page 8.)
3.
Attach the VGA ribbon cable to the Md4/PCV board. (The
connector is keyed to ensure correct installation.)
Attaching a VGA ribbon cable
4.
Install the Md4/PCV board. (See page 11.)
Preparing for Board Installation | 7
Advertisement
Table of Contents
