Installing The Display Controller - Planar Dome E4c Quick Reference Manual

Installing the Display Controller

Remove any existing graphics card and its driver from your computer system
before you install the AX5 controller and driver. Also disable any onboard
graphics capability on the motherboard. See safety precautions on page 2.
To install the controller
1 Turn off your computer and all
peripherals. Disconnect all cables
from your computer. Leave the
power cord plugged into the
grounded outlet.
2 Remove the computer cover.
3 Remove any existing graphics card
and video signal cable, if necessary.
4 Remove the blank bracket from the
available PCI Express slot.
5 Insert the controller into the slot,
align the connector pins, and
press the board down until it
is fi rmly seated.
6 Secure the mounting bracket.
7 Reattach the computer cover
and the peripherals.
6
Open PCI Express slot
Blank bracket
AX5 controller installed