Installing The Display Controller - Planar Dome Q2 Quick Reference

3

Installing the Display Controller

Turn your computer off. Leave the power cord plugged into the grounded outlet.
Remove any existing graphics card and its driver from your computer system before
you install the EX2 display controller and driver. Also disable any onboard graphics
capability on the motherboard.
To install the controller
1 Turn off your computer and all peripherals.
Disconnect all cables from the back of your
computer.
2 Remove the computer cover.
3 Remove any existing graphics card and
video signal cable, if necessary.
4 Remove the blank bracket from
the available AGP slot.
5 Insert the display controller into the AGP slot,
align the connector pins, and press the
board down until it is firmly seated.
6 Use the power extension cable to connect the
display controller to the computer's hard drive
connector. Connect the
the B plug to the computer power supply,
and the C plug to the hard drive connector.
6
A plug to the controller,
Open AGP slot
Blank bracket
EX2 display
controller installed