Installing The Display Controller - Planar Dome E2 Reference Manual

Installing the Display Controller

See safety precautions on page 2. Remove any existing graphics
card and its driver from your computer system before you install the
MX2 or MX3 board and driver. Also disable any onboard graphics capability
on the motherboard.
To install the controller
1 Turn off your computer and all
peripherals. Disconnect all cables
from your computer. Leave the power
cord plugged into the grounded outlet.
2 Remove the computer cover.
3 Remove the blank bracket from the
available PCI slot.
4 Insert the controller into the slot, align
the connector pins, and press the board
down until it is fi rmly seated.
5 Secure the mounting bracket.
6 Reattach the computer cover and the
peripherals.
When installing multiple display
controllers, install all of them before
you install the driver.
Blank bracket
MX2 or MX3 board installed
Open PCI slot
5