Installing the Display Controller
Remove any existing graphics card and its driver from your computer system
before you install the MX4 board and driver. Also disable any onboard graphics
capability on the motherboard. See safety precautions on page 2.
To install the controller
1 Turn off your computer and all peripherals.
Disconnect all cables from your computer.
Leave the power cord plugged into the
grounded outlet.
2 Remove the computer cover.
3 Remove any existing graphics card and video
signal cable, if necessary.
4 Remove the blank bracket from the available
PCI slot.
5 Insert the controller into the slot, align the
connector pins, and press the board down
until it is fi rmly seated.
6 Secure the mounting bracket.
7 Reattach the computer cover and the
peripherals.
6
Blank bracket
MX4 board installed
Open PCI slot