Supplementary Data; Radio Approval - Pilz PSEN sl-1.0p 3.1 Operating Manual

PSEN sl-1.0p 3.1
Mechanical data
Material
Top
Anchor plate
Base plate
Actuator
Max. torque setting for fixing screws
Dimensions
Height
Width
Depth
Actuator dimensions
Height
Width
Depth
Weight of safety switch
Weight of actuator
Weight
Where standards are undated, the 2015-04 latest editions shall apply.

Supplementary data

Radio approval

USA/Canada
FCC ID: VT8-PSENSLP
7482A-PSENSLP
IC:
FCC/IC-Requirements:
This product complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standards.
Operation is subject to the following two conditions:
1) this product may not cause harmful interference, and
2) this product must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this product not expressly approved by Pilz may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Le présent produit est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) le produit ne doit pas produire de brouillage, et
(2) l'utilisateur de le produit doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Operating Manual PSEN sl-1.0p 3.1
1003389-EN-04
PBT
Nickel-plated steel
Anticorodal, hard anodised
Anticorodal, hard anodised
3 Nm
172 mm
45 mm
44 mm
188 mm
52 mm
22 mm
1.120 g
590 g
1.710 g
31