Step 5: Manage The Cabling; Step 6: Connect The Microinverters - enphase IQ8 Series Installation And Operation Manual

Each Enphase microinverter, IQ Gateway, and IQ Battery have a removable serial number label. Build the
installation map by peeling the serial number labels from the microinverter mounting plates and placing the
labels on the map. You should also place the IQ Gateway and
IQ Battery serial numbers on the map after installation.
NOTE: Remove microinverter stickers before mounting the
PV module
After you have created the installation map, use the Enphase
Installer App to record serial numbers and configure the
system.
For details, refer to "Detect the Microinverters" in the help
topics of the Enphase Installer App.
A. Peel the removable serial number label from each
microinverter and affix it to the respective location on the paper installation map.
B. Peel the label from the IQ Gateway and any IQ Battery, (if installed) and affix it to the installation
map.
C. Always keep a copy of the installation map for your records.

Step 5: Manage the cabling

A. Use cable clips or cable ties to attach the cable to the racking. The IQ Cable must be supported at
least every 300 mm.
B. Dress any excess cabling in loops so that it does not contact the roof. Do not form loops smaller
than 120 mm in diameter.
WARNING: Dress the excess IQ Cable to avoid risk of cable insulation abrasion against the roof
surface.

Step 6: Connect the microinverters

A. Connect the IQ Cable to the microinverter. Listen for a click as the connectors engage.
B. IQ Cable connector can be inserted from any direction to the microinverter.
C. Seal any unused connector on the IQ Cable with IQ Sealing Cap. Listen for a click as caps engage.
17 © 2023 Enphase Energy Inc. All rights reserved.
IQ8AC/IQ8HC Installation and Operation Manual
Cable clip
Affix serial number labels
June 2023
USM-00005-2.0