Gold's Gym GGSY24618.0 User Manual page 24

38. Press the Left Upper Shroud (90) into the
Shroud Connector (93).
Then, attach the Left Upper Shroud (90) to the
Top Frame (4) with an M4 x 13mm Screw (94).
Do not tighten the Screw yet.
Repeat this step on the other side of the
weight system.
39. Press the Shroud Cover (88) onto the Right and
Left Upper Shrouds (89, 90).
Attach the Shroud Cover (88) to the Right
and Left Upper Shrouds (89, 90) with two
M4 x 13mm Screws (94).
See steps 37 and 38. Tighten the M4 x 13mm
Screws (94) used in these steps.
40. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
around the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is
used. See the CABLE DIAGRAM on page 29 for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 28.
38
90
4
94
39
89
24
93
88
94
94
90