Gold's Gym GGSY24618.0 User Manual page 19

25. Attach the Low Cable (53) to the U-bracket (45)
with an M6 Washer (82) and an M6 Locknut (33).
See the inset drawing. Do not overtighten the
M6 Locknut (33); it should be threaded onto
the end of the Low Cable (53) so that only
two threads are showing above the Locknut.
26. See the CABLE DIAGRAM. Identify the High
Cable (55).
Route the High Cable (55) upward through the
Top Frame (4) and over a Pulley (48). Make
sure that the eyelet end of the High Cable is
in the location shown.
Attach the Pulley (48) inside the Top Frame
(4) with an M10 x 68mm Bolt (71), two M10
Washers (57), two 13mm Spacers (52), and an
M10 Locknut (56).
27. Route the High Cable (55) over a Thin Pulley
(47) and downward through the Top Frame (4).
Attach the Thin Pulley (47) inside the Top Frame
(4) with an M10 x 68mm Bolt (71), an M10
Washer (57), and a 10mm Spacer (61). Make
sure that the Thin Pulley does not fall out of
the Top Frame while you complete steps 28
and 29.
Note: Another Thin Pulley (not shown) will be
installed inside the Top Frame (4) with the same
M10 x 68mm Bolt (71) in step 29.
25
33
82
45
53
33
53
26
55
56
57
52
Eyelet
27
19
45
4
48
57
71
52
47
4
55
61
57
71