Calibrating The Hoop; Entering The Fabric Thickness - Bernina 500 E Manual

Setup Program
> Touch the icon «Embroidery settings».
> Touch the icon «Center the embroidery motif».
> Press the switch in the right section.
> Press the switch in the right section again.

Calibrating the hoop

The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
•
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Calibrate the hoop».
> Center the needle via the arrow icons on the display.

Entering the fabric thickness

If the fabric thickness, as for e.g. toweling is more than 4 mm (0.15 inch) it is recommended to select 7.5
mm (0.29 inch) or 10 mm (0.39 inch). The thicker the fabric, the slower the embroidery speed of the
machine. When the machine is switched off, the alterations are reset to the default setting 4 mm (0.15 inch).
> Touch the icon «Home».
54
– A previously moved embroidery motif which has been saved in the new position is opened in the
saved position after selecting.
– The embroidery motif is centered to the embroidery hoop.
The embroidery module is connected and the embroidery hoop with the appropriate embroidery
template is attached.
1