Bernina 700 User Manual page 90

Errors and Faults
Message on the Display
90
Cause
The contact between the
machine and the embroidery
module is interrupted as a result
of vibrations.
The needle position doesn't
correspond with the center of the
hoop.
The embroidery module is not
attached.
The hoop is not attached.
The hoop is attached.
The movement of the hoop
follows.
The embroidery design is partly
outside the hoop.
Solution
> Make sure that the embroidery module and the machine
are standing on a stable, even surface.
> Connect the embroidery module to the machine.
> Calibrate the hoop.
> Connect the embroidery module to the machine.
> Contact the specialized BERNINA dealer to have the
machine checked.
> Attach the hoop.
> Remove the embroidery hoop.
> Tap «Confirm».
> Reposition the embroidery design and start
embroidering it again.