Table of Contents
Advertisement
3.3.4
Programming the Instruction Message
The instruction message follows the welcome message and scrolls across the screen from right to left
when the system is not in use. The instruction message can be a maximum of 48 characters (spaces
count as a character) and is entered into the system memory in three lines of 16 characters each.
The example below shows how the default instruction message was divided into three lines. Use the
blank matrix to organize your own message.
Default Instruction Message = PUSH A Z TO FIND NAME THEN PUSH THE CALL BUTTON
Example
PUSH A Z TO FIND NAME THEN PUSH THE CALL BUTTON
1
2
3
Line 1
P
U
S
Line 2
N
A
M
Line 3
H
E
1
2
3
Line 1
Line 2
Line 3
After organizing your instruction message in the matrix above, follow the instructions below to enter
the message into the system.
directory, remember to press * to enter that character. Spaces count as a character and must be
entered into memory as a character. After a complete line has been entered, press * to enter the line,
then start the next line.
1. Press *81 and enter the four-digit MASTER CODE _ _ _ _ (beep). The screen will
display: 1ST LIN INSTRUCT.
2. Enter up to 16 characters in line 1. Remember to press * (beep) after each character.
3. After the last character in line 1 has been entered, press * (beep) to enter the entire line.
The screen will display: 2ND LIN INSTRUCT.
4. Enter up to 16 characters in line 2. Remember to press * (beep) after each character.
5. After the last character in line 2 has been entered, press * (beep) to enter the entire line.
The screen will display: 3RD LIN INSTRUCT.
6. Enter up to 16 characters in line 3. Remember to press * (beep) after each character.
7. After the last character in line 3 has been entered, press * (beep) to enter the entire line.
8. Press * to enter all three lines into the system memory.
9. The new welcome message will begin to scroll across the screen.
3.3.5
Reset Instruction Message to Default
This programming sequence allows you to reset the welcome message to the factory default.
1.
Press *83 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter 1* (beep) to reset the message to default, or enter 0* (beep) to keep the
current programmed message.
4
5
6
7
8
H
A
Z
E
T
H
E
C
A
L
L
4
5
6
7
8
After each desired letter, number or space is displayed on the
9
10
11
12
13
T
O
F
I
N
P
U
S
B
U
T
T
O
9
10
11
12
13
1802-065-A-8-06
14
15
16
N
D
H
T
N
14
15
16
Page 33
Advertisement
Table of Contents
