Champion Global Power Equipment 93001i-EU Operator's Manual page 23

93001i-EU - 3000W PORTAbLE INvERTER GENERATOR
7. Dispose of used oil at an approved waste management
facility.

Once oil has been added, on flat level surface as a general rule
oil should be visible about 1-2 threads from top of the oil port
hole. If using the
dipstick to check oil level, DO NOT screw in the dipstick while
checking simply rest it against the top of the port and take
reading.
Cleaning and Adjusting the Spark Plug
1. Remove the spark plug access cover.
2. Remove the spark plug cable from the spark plug.
3. Use a spark plug socket tool , or a 13/16 in. (21 mm) socket
to remove the plug.
4. Inspect the electrode on the plug. It must be clean and not
worn to produce the spark required for ignition.
5. Make certain the spark plug gap is
0.024-0.031 in. (0.6-0.8 mm).
6. Refer to the spark plug types in Specifications when replacing
the plug.
NOTICE
SPARK PLUG GAP
7. Firmly re-install the plug.
8. Attach the spark plug cable to the spark plug.
9. Reinstall the spark plug access cover.
Cleaning the Air Filter
1. Recommended every 50 hours use or annually.Remove the
maintenance cover.
2. Locate the air filter plastic cover and remove by pinching the
clips together and pulling the cover off.
3. Remove the foam element.
4. Wash in liquid detergent and water. Squeeze thoroughly dry in
a clean cloth.
5. Saturate in clean engine oil.
6. Squeeze in a clean, absorbent cloth to remove all excess oil.
7. Place the filter in the assembly.
8. Reattach the air filter cover.
9. Reinstall the maintenance cover and tighten the cover screws
securely.
Cleaning the Spark Arrestor
1. Recommended every 100 hours use or 1 month.Allow the
engine to cool completely before servicing the spark arrestor.
2. Remove the 6 screws holding the cover plate on the muffler
side of the generator.
3. Remove the screw which retains the spark arrestor to the
muffler.
23
MAINTENANCE
EN