Surge Protection; Starting The Engine - Champion Global Power Equipment 93001i-EU Operator's Manual

93001i-EU - 3000W PORTAbLE INvERTER GENERATOR

Do Not modify or install any extensions or extraction to the
exhaust/muffler, by doing so will void any warranty.
Wet Conditions Alert: Do not expose to rain or use in damp
locations except as follows:
If you must operate in rain or damp locations, DO NOT operate
without proper protection of the electrical components.
Use of a safety canopy that is fire retardant and will provide proper
air ventilation for the engines exhaust stream can be used. Keep
all objects a minimum of 5 feet (1.5m) away from the generator at
all times. Heat from the muffler surface and exhaust stream can
ignite combustible materials.

Surge Protection

Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
– Install UL1449, CSA-listed, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They're designed to protect against virtually all short-duration
voltage fluctuations.

Starting the Engine

1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never start
or stop the generator with electrical devices plugged in or
turned on.
3. Turn the fuel cap vent lever to the "ON" position.
4. Turn EZ Start dial clockwise to the full "CHOKE" position.
CAUTION
5. When starting the engine, pull the recoil cord slowly until
resistance is felt, release cord back and with one strong rapid
pull to start, this avoids any kickback or damage to the recoil
assembly. If the engine doesnt start repeat this process
Rigorously or aggressively pulling the recoil cord will result in
damage to the recoil assembly and void any warranty.
6. As the engine warms up, move the EZ Start dial to the "RUN"
position.
For petrol restarts with hot engine and(or) in hot ambient
temperature >86°F (30°C): Rotate the EZ Start dial to
the "CHOKE" position for only one pull of the recoil cord. If
generator does not start after first pull, rotate the dial to the
"RUN" position for the next three pulls. Too much choke leads
to spark plug fouling and engine flooding. This will cause the
engine not to start.
For petrol starting in standard ambient temperature
>59°F (15°C): Keep EZ Start dial in "CHOKE" position for three
pulls of the recoil cord. If generator does not start after three
pulls, rotate the EZ Start dial to the "RUN" position for the next
three pulls. Too much choke leads to spark plug fouling and
engine flooding. This will cause the engine not to start.
18
OPERATION
CAUTION

NOTICE

NOTICE
