Elba EHS 935D1 SB Instructions For The Use page 14

After connecting the appliance to the gas supply, make sure that you
•
check that the connections are correctly sealed using a soapy solution, but never a
naked flame.
•
check whether the injectors are correct for the type of gas being used. If not, follow the
instructions under "GAS MAINTENANCE".
•
replace the sealing washer/s on the slightest sign of deformation or imperfection. The
sealing washer/s is/are the part/s which guarantee/s a good seal in the gas connection.
GAS CONNECTION WITH RIGID PIPES OR A FLEXIBLE HOSE
The gas connection fitting (fig. 2.2) is made up of:
•
the appliance inlet pipe;
• the floating nut;
•
the brass elbow;
•
the sealing washers.
Important!
■ If fitted, remove the hose holder from the terminal fitting of the inlet pipe.
Fig. 2.2
Gas connection with rigid pipes or a flexible hose
Note: if already fitted on the inlet pipe, remove the rubber hose holder
(ISO 228-1) female
14
Turning the gas
connection fitting
Sealing washer
1/2" G cylindrical
Flexible hose
(not supplied)
1/2" G cylindrical
(ISO 228-1) male
Brass elbow
1/2" G cylindrical
(ISO 228-1) male
Sealing washer
Floating nut
1/2" G cylindrical
(ISO 228-1) female
Rigid pipe
(not supplied)
Appliance
inlet pipe