Table of Contents
Advertisement
B-12
Weld Machine Settings Screen:
Overview
The user must enter the proper welding procedure
and process settings, including wire feed speed,
amperage, voltage, polarity, and trim where applica-
ble. As in the gas setup screen, the user must enter
values within the acceptable range as governed by
the tolerance editor. If not, they will be notified by the
incorrect weld setting screen when the green check
settings button is pressed.
The user changes the wire feed speed or amperage
by rotating the wire feed speed/amperage dial. The
display above the dial indicates the setting.
The user changes the voltage by rotating the voltage
dial. The display above the dial indicates the setting.
Some processes may not allow the user to pre-set
the voltage, in which case the display will be blank.
WELD MACHINE SETTINGS SCREEN
Polarity Selector
Change the polarity by rotating the polarity selector
switch. The user can select the following:
• AC
• DC+
• DC-
If default tolerances are being used, refer to the
Default Weld Process Settings included in this
manual.
Once the user has set the welding parameters, they
should press the green check settings button. If the
user has entered any settings outside the acceptable
range specified by the settings in the tolerance editor,
the incorrect weld setting screen will appear.
OPERATION
The user will then have to change any settings that
are not correct. If the settings are correct and the
green check settings button is pressed, the welderʼs
view screen will appear on the monitor and in the hel-
metʼs stereo visor. The user will then be able to start
virtual welding.
THE INCORRECT WELD SETTINGS SCREEN
THE CORRECT WELD SETTINGS SCREEN
Menu
Selecting Logout brings the user back to the login
screen, with the userʼs name removed.
Back
Pressing Back goes back to the previous screen.
Virtual Welding Overview
While a user is welding, observers can see the
Welderʼs view, LASER screen, or Instructorʼs view
displayed on the monitor. The Welderʼs view shows
what the user with the helmet on is seeing through the
FMD. The LASER screen displays a real time graph
of the weld being made and gives a score when the
user selects "end pass". The Instructorʼs view allows
another user to zoom in/out and rotate the coupon to
view the weldment from different angles in real time.
VRTEX
360
®
B-12
Advertisement
Table of Contents
