A-6
Table
TABLE & SWING ARM SET-UP:
1. Place counter weights on base.
2. Using the 3/16" (4.8 mm) allen wrench, remove the
two 1/4" x 20 Allen-head screws from the base
assembly.
NOTE: The longer screw is in the top.
3. Insert red post into base assembly aligning the flat
on the pole with the hole.
NOTE: The post will only insert one way.
4. Using the 3/16" (4.8 mm) allen wrench, secure the
post into position by replacing and tightening the
screws.
INSTALLATION
5. Obtain the three post T pins from the factory pack-
Screws
Table
Base
Weights
6. Insert one of the pins into the post at the #6 loca-
7. From the top, slide the table onto the post letting it
8. Insert the second pin into the post at the #13 posi-
9. Obtain the swing-arm from the rear of the VRTEX
VRTEX
360
®
aging of the VRTEX
360.
®
Swing Arm
tion.
rest on the pin inserted in previous step.
tion.
360 by removing the cable ties from the swing arm
and cable. Grey cable should remain connected to
the VRTEX
360 (DO NOT CUT THE GREY
®
CABLE!).
A-6
Post
Pins
®