A-5
2. Using the 3/8" (9.5 mm) wrench, remove the screws
from the upper and lower front panels on the ship-
ping crate.
NOTE: Do not remove rear panel.
DO NOT
REMOVE
REAR PANEL
3/8" BOLTS
3. Remove the six 3/8" bolts (three on each side) from
the bottom of the crate assembly.
4. Carefully slide the crate assembly from the
VRTEX
360.
®
5. Slide towards the rear of the machine. Be careful to
avoid damaging the welding device holders located
on each side of the machine.
6. Carefully remove the post (long cylinder-shaped
cardboard) from the crate.
INSTALLATION
7. Carefully cut and remove plastic wrapping.
8. Remove the monitor from the front of the machine.
REMOVE
FRONT PANELS
STEP (2)
9. Using the 3/8" wrench, remove the two screws from
the rear base securing the unit to the wooden crate.
10. Remove the four screws from the wooden rear
cross brace.
11. Remove the wooden cross brace while ensuring
the unit is steady and secure.
12. Carefully roll the machine off the rear of the skid.
Ramping may be required.
13. Uncrate and unpack the table and table base.
VRTEX
360
®
A-5