Table of Contents
Advertisement
B-10
Table/Arm Rotation
Move the physical VR table and arm to the desired
location for the position and joint configuration select-
ed. To raise or lower the arm or table, hold the
arm/table in place and pull out the pin in the pole sup-
porting it. Replace the pin in the hole that supports
the arm/table at the proper height and rest the
arm/table on the pin.
swing the table to the left or right and out of the way.
The arm can also be rotated to the left (A), center (B)
or right (C) of the table.
SWING ARM ROTATION
TABLE ROTATION
OPERATION
If the table is not needed,
VRTEX
Pin Positions
When the physical stand is in the desired position,
proceed with the following: Use the joystick and red
select button to enter the numbers that appear next to
the pin positions for the table and arm height into the
stand setup screen. The image on the right side of
the stand setup screen moves to match the selections
entered on the left. If the table is in the "away" posi-
tion, enter a table height value of 0. Next, enter the
arm rotation position A (left), B (center), or C (right).
The arm position letter aligns with the vertical pin
number sticker. An arm height of 18 and arm rotation
of A are shown in the picture below.
PIN POSITIONS 18 A
Note: If the table height indicator in the software
cannot be moved to the pin height indicated
on the post, move the arm height indicator
in the software to a higher position and try
again. See Troubleshooting Guide if neces-
sary.
360
®
B-10
Advertisement
Table of Contents
