Table of Contents
Advertisement
B-11
Indicate the coupon orientation used on the physical
stand in the coupon rotation area of the stand setup
screen. The red arrow indicates which side of the
coupon that the weld will be made. For pipe configu-
rations, the coupon rotation is replaced with arm
angle. The arm angle can be adjusted by removing
the pin at the end of the arm, rotating the arm to 45 or
90 degrees from its original location, and reinserting
the pin. This is only used to accommodate 2G, 5G
and 6G pipe welding.
STAND SET-UP SCREEN (PIPE)
The physical stand should match the stand image
when these selections are completed. To continue,
press the green continue button. The stand setup ver-
ification screen will be displayed. This screen serves
as a reminder to make sure VR stand components
match the screen. When verified, press the green
continue button again.
STAND SET-UP SCREEN OVERLAY
Back
Selecting Back takes the user to the previous screen.
Environment Screen:
Overview
The VRTEX
360 comes pre-configured with a num-
®
ber of different virtual welding environments. To
select an environment, the user moves the joystick left
or right and then presses the red select button or
green continue button to choose the environment.
OPERATION
Menu
Selecting Logout takes the user back to the login
screen, with the userʼs name removed.
Back
Selecting Back takes the user to the previous screen.
Gas Set-Up Screen:
Overview
On this screen, the user selects the gas mixture and
gas flow rate. The correct gas mixture and flow rate
must be entered according to the tolerance editor. If
acceptable values are not entered, this will be indicat-
ed on a later screen and the user may have to go
back and change the selection on this screen.
To select the gas mixture, use the joystick and the red
select button. The available gas mixtures are shown
on the gas set-up screen below.
To select the gas flow rate, use the joystick. Press
the red select button or green continue button to pro-
ceed.
Menu
Selecting Logout takes the user back to the login
screen, with the userʼs name removed.
Back
Selecting Back takes the user to the previous screen.
VRTEX
360
®
ENVIRONMENT SCREEN
GAS SET-UP SCREEN
B-11
Advertisement
Table of Contents
