Table of Contents
Advertisement
B-4
Helmet
HEAD SIZE ADJUSTMENT: HEADGEAR TIGHTNESS is
adjusted by pushing in the Ratchet Knob and turning to
adjust for the desired head size. This knob is located at the
back of the helmet. HEADGEAR CROWN ADJUSTMENT
is made by adjusting for comfort and snapping the pin into
the hole to lock securely in place.
Tilt
Crown
Adjustment
Tilt
Adjustment
Fore-Aft
Adjustment
TILT: Tilt adjustment is located on right side of helmet.
Loosen the right headgear tension knob and push the top
end of the adjustment lever outward until the leverʼs Stop
Tab clears the notches. Then rotate the lever forward or
back to the desired tilt position. The Stop will automatically
engage again when released locking the helmet into posi-
tion.
FORE / AFT ADJUSTMENT: Adjusts the distance between
the userʼs face and lens. To adjust, loosen the outside ten-
sion knobs and slide forward or back to desired position and
retighten. NOTE: Make sure both sides are equally posi-
tioned for proper operation.
HELMET LENSES
The helmet has an FMD (Face Mounted Display) on
the inside. These FMD lenses display the virtual envi-
ronment to the user. Each lens can be shifted left or
right to align with the users eyes by applying gentle
pressure. In addition, the lenses can be lifted up and
down as well as shifted forward and back for the best
fit. The user should make sure the lenses are parallel
to their eyes. Keep the lenses clean at all times. See
Cleaning and Maintenance Section D.
LENSES
OPERATION
Lenses
Ratchet Knob
Push In
*
NOTE:
Do not remove or adjust
ear buds on headband.
EAR BUDS
The ear buds are close
to the ears so the opera-
tor can hear the proper
welding sounds.
*
Condensation on lenses may
appear in high humidity enviro-
FMD for approxi-
ment. Run
mately 10 minutes to clear
up moisture from the lenses.
When not in use, the helmet should be hung from the
stand or placed in the right front drawer to avoid being
damaged.
A welding cap should be used and headgear should
be cleaned before using the Helmet.
Coupon Drawer
The coupon drawer houses the physical coupons.
When not in use, the coupons should be stored in the
drawer. To open the drawer, press the top indent
down, and slide the drawer out. Each coupon fits in
its own area defined by the foam locator in the draw-
er.
Coupons
The coupons represent the various workpieces on
which the user can virtually weld. During the virtual
welding process, they provide physical feedback to
the student.
There are five VR Coupons:
1. Flat Plate
2. T-Joint
3. 3/8" Groove Joint w/Backing Bar
4. 2" Diameter XXS Pipe
5. 6" Diameter Schedule 40 Pipe
4
1
The coupons along with the VR SMAW device and VR
GMAW/FCAW gun have been factory calibrated at
Lincoln Electric.
VRTEX
360
®
COUPON DRAWER
VR COUPONS
5
B-4
2
3
Advertisement
Table of Contents
