Settings Via Mppt Control Display; All Settings Explained - Victron energy SmartSolar MPPT 150/45 Manual

Switch Suggested
position battery type
Lithium Iron
Phosphate
7
(LiFePo4)
batteries
* The top value is for 12V systems, the middle for 24V systems and the bottom for 48V systems.
** Equalize is by default disabled. To enable see chapter
A binary LED code helps determining the position of the rotary switch. After changing the position of the rotary switch, the LEDs
will blink during 4 seconds as indicated in below table. Thereafter, normal indication resumes, as described in the LEDs section.
Switch position
0
1
2
3
4
5
6
7

5.1.3. Settings via MPPT Control display

The MPPT Control display can be used to configure solar charger settings, with the exception of advanced settings such as RX
and TX port settings. For information how to do this see the

5.2. All settings explained

This chapter lists all solar charger settings that are user-configurable and also explains how to update firmware of the solar
charger.
Do not change settings unless you know what they are and what the effect of changing these settings will
be. Incorrect settings may cause system problems including damage to batteries. When in doubt, seek advice
from an experienced Victron Energy installer, dealer or distributor.
Page 15
MPPT solar charger manual
Float
Absorption
voltage*
voltage* (V)
(V)
14.2 13.5
28.4 27.0
56.8 54
Bulk LED Absorption LED
1 1
0 0
0 1
0 1
1 0
1 0
1 1
1 1
MPPT Control display
The MPPT Control display
Equalize**
Equalize** nominal
voltage* (V) current
percentage
n/a n/a
Battery settings [16]
Float LED Blinking frequency
1
1
0
1
0
1
0
1
manual.
Configuration and settings
Temperature
compensation
factor* (mV/°C)
0
0
0
Fast
Slow
Slow
Slow
Slow
Slow
Slow
Slow