Victron energy SmartSolar MPPT 150/45 Manual page 33

• If more devices need to be added to this network go to next paragraph and join multiple devices to the network.
To join another device to an existing network:
• Open the VictronConnect app. Select a device that needs to become part of a VE.Direct network.
• Navigate to the settings page by clicking the gear
• Click on "VE.Smart networking".
• Click on "join existing".
• Select the network the device needs to be joined to.
• Wait for confirmation that the network has been set up and click "OK".
• Repeat above steps if more devices need to be added to the network.
To leave a network:
• Open the VictronConnect app.
• Select a device that needs to be removed from the VE.Direct network.
• Navigate to the settings page by clicking the gear
• Click on "VE.Smart networking".
• Click on "leave network".
Check the network
Once the network has been set up all devices communicate with each other. The active LED on each connected device will now
blink every 4 seconds. This is an indication that the device is actively communicating with the network.
To check if an individual device is communicating with the network, click on the VE.Smart symbol
the solar dail. A pop-up window will open showing the connection status and the shared parameters.
To check if all devices are actively communicating with the same VE.Smart network, navigate to the settings page of one of the
networked devices and click on "VE.Smart networking". A screen will be shown containing which device parameters of this device
are shared and all the other devices that are connected to the same network are shown.
Page 30
MPPT solar charger manual
symbol.
symbol.
VE.Smart network pop-up
in the main screen next to
Configuration and settings