Setup; First Setup; First Setup Via Wifi Access Point - Victron energy EV Charging Station Manual

4. Setup

4.1. First setup

4.1.1. First setup via WiFi access point

The charging station broadcasts its own WiFi access point as soon as the charging station is powered for the first time. The
following steps describe the first setup to prepare the charging station for operation.
1. Connect to the WiFi access point:
I. Scan the QR Code on the internal label.
II. Or go to the WiFi menu of your mobile device or laptop and manually add the access point that broadcasts automatically
its SSID. SSID and WiFi key are noted on a sticker inside the case.
III. Or scan the QR code shown on the display during the first setup phase. Note that after the first setup, another QR code
will appear on the display, linking to the Victron website.
Once connected to the access point, enter the default IP address 192.168.0.1 into a web browser. The First setup process will
then start:
2. WiFi setup: Configure the WiFi network by choosing the WiFi mode
I. Access point: The unit creates its own WiFi access point. This is either for setting up the unit or in the absence of a
separate WiFi network including a GX device. Set SSID, IP address and Netmask according to your needs.
1. Set SSID, IP address and Netmask according to your needs.
II. Station: Connects the device to a local WiFi network that includes other Victron devices like a GX device or VRM.
1. Change the WiFi mode from AP to Station.
Page 5
Manual - EV Charging Station
Setup