Table of Contents
Advertisement
Fault
The machine doesn't start
Neither the sewing light nor
the light on the free arm
lights up
Upper thread indicator
doesn't react
Bobbin thread indicator
doesn't react
Error during software update
BSR presser foot #42 not
detected
17.3 Error messages
Message on the display
Cause
Unfavorable room temperature.
The machine is damaged.
Settings in the Setup Program.
The sewing light is defect.
Settings in the Setup Program.
The upper thread indicator is
defect.
Settings in the Setup Program.
The bobbin thread indicator is
defect.
USB stick is not recognized.
The update process is blocked
and the hourglass on the display
is inactive.
Date of the software update
cannot be found.
Lens is dirty.
BSR cable not inserted correctly.
Cause
Stitch number unknown.
Selection of the stitch pattern not
possible in the combi mode.
Solution
> Place the machine in a warm room one hour before use.
> Connect the machine and switch it on.
> Contact the specialized BERNINA dealer.
> Activate it in the Setup Program.
> Contact the specialized BERNINA dealer.
> Activate it in the Setup Program.
> Contact the specialized BERNINA dealer.
> Activate it in the Setup Program.
> Contact the specialized BERNINA dealer.
> Use a BERNINA USB stick.
> Remove the USB stick.
> Switch the machine off.
> Switch the machine on.
> Follow the instruction on the display.
> Unzip the update data.
> Save data of the software update directly on the data
medium and not in a file on the USB stick.
> Clean the lens with a soft, slightly damp cloth.
> Insert the BSR connector vertically until you feel it click
into place.
Solution
> Check the entry and enter the new number.
> Combine other stitches.
Appendix
181
Advertisement
Table of Contents
