Network; Basic Setup - Planet ICA-3480F User Manual

H.265 plus 4mp full color ip camera

Hide thumbs Also See for ICA-3480F:

Table of Contents

User's Manual of ICA-3480F/ICA-4480F

6.3 Network

In the main interface, click "Config  Network" to enter the network settings interface, the

network is divided into Basic Config, P2P and Email configuration.

① TCP/IP

The TCP/IP interface is used to view and configure network parameters such as the

camera's IP address. You can enable DHCP or manually modify to configure the IPC

network parameters.

Enable DHCP:

Connect IPC to the router with DHCP enabled, and then IPC will obtain the

corresponding IP address, subnet mask, default gateway, and preferred DNS server

information.

The specific steps for manually modifying network parameters are as follows:

Step 1: In the main interface, click "Config  Network  Basic Setup  TCP/IP" to enter the

TCP/IP interface, as shown in Figure 6-6 ①.

Figure 6-6 ①

Step 2: Set the IP address (IPv4 or IPv6 format), subnet mask, gateway, and DNS.

Step 3: Click "Test" to make sure the modified IP address is available in the LAN.

Step 4: Click "Apply" to save the configuration.

Port

In the main interface, click "Config  Network  Basic Setup  TCP/IP" to enter the TCP/IP

setting interface, where you can set the IP Camera network port and protocol port. The

network port has HTTP port (default is 80), RTSP port (default is 554), HTTPS port (default is

443), and BITVISION port (default is 6000). The protocol port has the ONVIF port (default is

8999), as shown in Figure 6-6 ②.

Table of Contents

Ica-4480f