Using The Remote Control; First Time Installation; Dvb-S/S2 Installation - Strong SRT 24HC3023 User Manual

Precautions for using the battery
Improper using of the battery will cause leakage. Carefully follow these instructions.
1. Please note the batteries' polarity to avoid short circuit.
2. When the battery's voltage is insufficient which affect the use range, you should replace it with
a new battery. Remove the batteries from the remote control unit if you do not intend to use it
for a long time.
3. Do not use different types of batteries (for example Manganese and Alkaline batteries) together.
4. Do not put the battery into fire, and charge or decompose the battery.
5. Please dispose batteries abide by relevant environmental protection regulation.

2.6 Using the remote control

Use the remote control by pointing it towards the remote sensor. Items between the remote

control and the remote sensor could block normal operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote

control, also do not put the remote control in a high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit

by heat.
When the remote sensor is under direct sunlight or strong lighting, the remote control will not

work. If so, please change the lighting or TV's position, or operate the remote control closer to
the remote sensor.

3.0 FIRST TIME INSTALLATION

After all connections have been properly made, switch on your TV. The language selection will appear
on screen. Use   to select the OSD Language of your preference. Press  and then use   to select
the country where you will use this TV. This is important to set settings as time zone and text character
correctly. Press  to change Environment from Home to Shop modus to demonstration TV in shop,
otherwise keep as it is.
Press ENTER for next step to go to Tuning setup.
In Tuner setup selection you select which tuner input source you like to use.
Tuner Type
Digital type
Next step is depending of your choice in Tuner setup.

3.1 DVB-S/S2 installation

Satellite
Press  to select Satellite and use   to highlight the satellite your dish is aimed at. Use    to
highlight the options of choice and press ENTER to start the channel search.
Scan Mode
Channel type
If you still have analogue signals in DVB-T or DVB-C. Select here between
options of Digital /+ Analogue systems.
Satellite to receive satellite broadcasts if you are equipped with a satellite
dish),
DVB-T to receive terrestrial broadcasts with indoor or outdoor antenna.
DVB-C to receive cable broadcasts if you have cable connection from local
provider.
Choose between Default (recommended), Blind Scan and Network
Select Free to search Free-To-Air channels only Free + Scrambled to search FTA
and Encrypted channels or Scramble to search Encrypted channels only.
7