Dolmar MG5300.4 Original Instruction Manual page 8

2. Loosen and remove the clamp screw.
► 1. Clamp screw
Be careful not to twist the cable when assembiling the
control handle.
3. Install the control handle / handle assembly onto
the swivel pipe and tighten them with the clamp screw.
► 1. Control handle 2. Clamp screw
4. Attach the flexible pipe to the elbow
Insert the elbow to the flexible pipe. Attach the cable
holder between the hose band and the flexible pipe.
Tighten the cable holder, flexible pipe and elbow with
the hose band. Set the control cable onto the cable
holder, and close the cable holder.
1
► 1. Elbow 2. Cable holder 3. Hose band
1
1
2
3
2
8 ENGLISH
1
► 1. Cable holder 2. Control cable
5. Attach the long/short pipe to the swivel pipe. Turn
the long/short pipe clockwise to lock it into place. Then
attach the blower nozzle with the long/short pipe. Turn
the blower nozzle clockwise to lock it into place.
1
► 1. Long/short pipe 2. Blower nozzle
6. Make sure all clamps are tight. Check if the trottle
valve moves correctly along with the throttle movement.
2
2